|
What roller diameters do you
produce?
What do I measure to ensure the proper width
of a replacement roller?
What type of conveyors do you manufacture and
are there any restrictions to what you will design?
What is your turnaround time?
Can you install the equipment?
Do you Engineer and Manufacture on site?
Can you design and build electrical controls?
Can you match up with our existing conveyors
and equipment?
How would I go about being employed by Almac
Conveyor Co. Ltd.?
What roller diameters do you produce?
We have the capability in our Roller Making Department to
custom-manufacture any diameter roller. However, we do offer
the following STANDARD sizes:
|
Roller Outside Diameter
|
Roller Wall Thickness
|
Hex Axle Width (flat to flat)
|
|
1-3/8"
|
14 GA.
|
5/16"
|
|
1-5/8"
|
16 GA.
|
7/16"
|
|
1.9"
|
16 GA.
|
7/16"
|
|
1.9"
|
9 GA.
|
7/16"
|
|
2-1/2"
|
14 GA.
|
7/16"
|
|
2-1/2"
|
11 GA.
|
11/16"
|
|
3-1/2"
|
.216 WALL
|
1-1/16"
|
|
3-1/2"
|
.300 WALL
|
1-1/16"
|
What do I measure to ensure the proper
width of a replacement roller?
The B.F.R. (between frame rail) measurement is the most important.
This is the measurement from the inside of the left frame
rail to the inside of the right frame rail. As bearing dimensions
may differ, this is the most accurate measurement to ensure
replacement rollers will fit the frame properly.
What type of conveyors do you manufacture
and are there any restrictions to what you will design?
There are no restrictions to our design capabilities (other
than the laws of physics). We will custom design and manufacture
a conveyor system to meet your application requirements.
What is your turnaround time?
This is project specific, dependent on the scope of your
equipment needs and our shop loading schedule. Small orders
are typically 2-4 weeks, if shop loading is at a minimum.
Conversely, any changes you might make along the manufacturing
pipeline can affect the delivery date and price.
Can you install the equipment?
Yes. We have the personnel to carry out on-site installations.
We also work closely with mechanical installation sub-contractors
to ensure that there is always a trained installation professional
available to ensure our equipment is installed properly.
Do you Engineer and Manufacture on site?
Yes. We have the facilities for on-site Engineering, Machining,
Fabricating, Assembling, Electrical, Programming and Testing.
Can you design and build electrical controls?
We have the staff and facilities on-site to design, build
and test all electrical controls from a simple limit-switch,
to PLC control panels that operate entire plants of machinery.
Can you match up with our existing conveyors
and equipment?
Although the standard off-the-shelf conveyor is more economical,
we can custom-design and build conveyor equipment to match
up perfectly to your existing equipment. Or, we are able to
replace parts of your existing systems and equipment. Our
team of engineers has mated our equipment to hundreds of different
conveyors/equipment in the past.
How would I go about being employed by
Almac Conveyor Co. Ltd.?
Please e-mail your resume to almac@almac.com,
using the subject heading "Personnel Department".
|
